|
We understand with Xfrog Creation of a New Year's tinsel |
||
 |
||
|
We create object Branch from panel Xfrog. |
 |
|
|
We create Spline necessary to us for work. Worth by default Spline we delete, also we put instead of it ours to a spline:). I shall create spline as letter "П", as though the tinsel hangs at a window. |
|
 |
|
Parameter Radius in object Circle we put 4 meters. For uniform thickness of "stalk" of a tinsel Parameter Thickness of object Branch we change so, that points were approximately at one level. |
 |
|
|
Now we shall create "needles". Again we create object Branch from panel Xfrog, we change radius Circle on 2.5, we put a tick on Ellipse, Radius Y - 5m. We delete deault Spline and instead of it we put the. I for convenience put chamber Front (F4), and from this foreshortening I draw Spline, it is desirable from the center of crossing of axes. And all this we throw in the first Branch, that it only not prevented his options. |
 |
|
|
Now it are necessary to adjust both Branch. Let's start with enclosed Branch. For convenience of adjustment in parameters Branch let's allocate with mousy Object and Nodes. |
 |
|
|
Thickness we shall adjust as a hill, where the middle It is approximately equal, the first point is higher, last is lower. Node Preset-Perpendicular. I shall describe that I change, other parameters I has left as was. Now we shall adjust "stalk" (the basic Branch). For Nodes we put 160. Node Multiplicity 5. Node Distribution we put in a line in the middle. Node Screw it is lifted almost up to top, the left point should be in the top, bottom hardly it is less. Node Growth, responsible length of "needles" we put on third. |
 |
|
|
Well also we shall impose favourite Nukei c multi-coloured specular. Like all. In general this way it is possible to stir up much that. Seaweed, prickly to the prowolf, fur-trees, etc. Successful experiments! |
 |
|
 |
||